Skip to main content
Hilti

Features & Applications

Features
  • No hole cleaning required when using HIT-Z anchor rods
  • Automatic hole cleaning with TE-CD and TE-YD hollow drill bits in combination with Hilti vacuum cleaners
  • Fulfills the requirements of the most demanding ICC-ES and ETA C2 approvals for seismic applications
  • Working time optimized for anchor applications
  • Suitable for use in cracked and uncracked concrete with all anchor rods and rebar
Applications
  • Anchoring structural steel connections (e.g. steel columns, beams)
  • Anchoring secondary steel structures (e.g. racking, guard rails, sound barriers)
  • Anchoring safety barriers, balustrades, fire staircases
  • Seismic strengthening / retrofitting and bracing of reinforced concrete buildings
  • Structural splices / straight connections with post-installed rebar

Technical Data

Documents & Videos

Consulting & Support

Better adhesives mean stronger anchors

Don’t sacrifice confidence for convenience. With the Hilti Adhesive Anchor system, you get both.

Worried about the demands of the job? Relax. We’ve formulated two special adhesives— HIT-HY 200-R (regular working time) and HIT-HY 200-A (advanced working time)—to handle just about anything the job throws at you. HIT-HY 200 is approved for use in uncracked and cracked concrete in all seismic zones, grout filled masonry, and now you take no reductions for use in water saturated concrete (Category 1). 

How about anchor concerns? Post-installed rebar is a given. It’s one of the most popular uses for the HIT-HY 200 System. You also have several threaded-anchor choices to match your budget and the scope of your project. In fact, we’ve even engineered one of them—our Hilti HIT-Z anchors with a cone-shaped helix design—specifically for timesaving, labor-saving Safe Set™ Technology installation.

Two quicker routes to a job well done

Drill clean holes for rebar and threaded anchors, in one step.

One of the differences behind SafeSet™ Technology is the hollow drill-bit technology that removes concrete dust as you drill, eliminating a half-dozen hole-cleaning steps. That’s enough to reduce the time for installation labor by up to 60 percent as compared to traditional methods. This total solution works with Hilti SDS-Plus and SDS-Max hammer drill connections and Hilti vacuums.

HY 200 with Hollow Drill Bit and VC 20/40 Vacuum

Or skip the cleaning altogether with HIT-Z anchors.

If you want to use a threaded anchor, you can skip the hole-cleaning process altogether simply by choosing Hilti HIT-Z anchors. Go right from drilling the hole to inserting the adhesive and setting the anchor. It doesn’t get any simpler than that.

HY 200 with HIT-Z anchors
Log in to proceed
Register now
Contact us
Contact
Added to cart
Added to cart
Go to shopping cart